Graco SMVector - Frequency Inverter Bedienungsanleitung PDF herunterladen (Seite 45)

SV01M

Commissioning

Code

Display Range (READ ONLY) IMPORTANT

No. Name

Sequencer: Currently

Active Segment

0 17

Sequencer: Time

since Start of Active

Segment

0.0 {P708} 6553.5

0 {P708} 65535

Unit depends on P708 (0.1sec, sec or minutes)

Sequencer: Time

Remaining in Active

Segment

0.0 {P708} 6553.5

0 {P708} 65535

Unit depends on P708 (0.1sec, sec or minutes)

Sequencer: Number

of cycles since start

0 65535

Sequencer: Number

of cycles remaining

0 65535

NOTE: Parameters P560-P564 are visible only when P700 > 0 (i.e. the sequencer is enabled)

4.5.7.1 Terminal & Protection Status Display

Parameter P530 allows monitoring of the control terminal

points and common drive conditions:

An illuminated LED segment indicates:

• the protective circuit is active (LED 1)

• the Logic Assertion Switch is set to High (+)

• input terminal is asserted (LED 2)

• output terminal is energized (LED 4)

• the Charge Relay is not a terminal, this segment will

be illuminated when the Charge Relay is energized

(LED 4).

Input 13C

Input 13A

Factory Reserved

Protective Diagnostic

Current Limit Diagnostic

Logic Assertion Switch

Input 1

Input 13B

Relay

Output 14

Input 13D*

* Input 13D available on 15-60HP (11-45kW) models only

LED #

1 2

Charge

Relay

Auxiliary Relay

Input 13F

Input 13E

Additional I/O Module only

4.5.7.2 Keypad Status Display

Parameter P531 allows monitoring of the keypad pushbuttons:

An illuminated LED segment indicates when the button is depressed.

LED 1 and LED 2 are used to indicate pushbutton presses on a remote

keypad that is attached to the drive. LED 3 and LED 4 indicate button

presses on the local drive keypad.

CTRL

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 65 66

Kommentare zu diesen Handbüchern

Keine Kommentare

Graco SMVector - Frequency Inverter Bedienungsanleitung Seite 45

Kommentare zu diesen Handbüchern