Graco 249065 Bedienungsanleitung

309828NINSTRUCTIONSImportant Safety InstructionsRead all warnings and instructions in thismanual. Save these instructions.G–Force Direct-Drive Pressur

10 309828Trigger Safety LatchAlways engage the safety latch when you stop spraying.Always engage trigger safety latch when you stop spraying even for

113098281. Follow Pressure Relief Procedure, page 7.Chemical Injector Operation2. Push end of chemical injector hose over chemical injector fitting

12 309828Spray tips have 4– or 5–digit numbers on them.The first two digits are the spray angle. Tipholding holes are provided on the chassis.1. Pe

13309828Shutdown, Flushing, and Storage1. Remove chemical injector hose from pump, if attached.2. Trigger gun for one minute to flush pump with clea

14 3098285. Shut off water supply. Disconnect water supply hose from pump.6. Remove trigger safety latch and trigger gun to relieve pressure.7. Re

15309828ENGINE:1. Run engine until gas is gone or stabilize the fuel and run it through the fuel system and carburetor.2. Drain water out of pressur

16 309828Maintenance Chart Perform Pressure Relief Procedure (page 7).Interval What to doDaily Clean water inlet screen and filter.

17309828Troubleshooting Perform Pressure Relief Procedure (page 7).Problem Cause SolutionEngine will not start oris hard to start.No gasoline in fuel

18 309828ProblemCause SolutionPackings are failingfreq entl orScored, damaged, or worn plungers Install new plungers.frequently orprematurelyAbrasive

19309828Pump ServiceRepair kits are available. See the Parts Lists (page 21). For the best results, use all parts in the kits. Perform Pressure Relief

2 309828Table of ContentsSymbols 2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Warnings 3. . . . . . . . . . . . . . .

20 309828PackingsDisassembly1. To access water seals for inspection or replace-ment, remove head of pump.Note: It is important to note the order in

21309828PartsModel 2525LD43,44332120 232426254593615123432101345222930281617141322876235273140ti7343a56

22 309828PartsModel 2525LDRef.No.PartNo.Description Qty.1 15C311 HANDLE, cart 12 15B880 FRAME, placard 13 15C307 RACK, hose 14 115651 NUT, acorn 25 80

23309828Repair KitsSJV2.5G25D–F7 (Use with model 2525LD)66556349474843444627303132131415171819162133363728412346678101195512232440162262538573534ti608

24 309828PartsModel 2626LDti7344a43,44332120 23242625459361512343210134522293028161714133122876227403556

25309828PartsModel 2626LDRef.No.PartNo.Description Qty.1 15C311 HANDLE, cart 12 15F136 FRAME, placard 13 15C307 RACK, hose 14 115651 NUT, acorn 25 805

26 309828Repair KitsSJV2.5G27–D105 (Use with Model 2626LD)55494748434446273031321314151718191621333637284110119122324401234567856ti6163b62456366382625

27309828Technical DataModel 2525LDWorking pressure rangeOperating Pressure 2300 psi (159 bar, 15.8 MPa)Maximum Working Pressure 2500 psi (172 bar, 17.

28 309828Graco Standard WarrantyGraco warrants all equipment listed in this manual which is manufactured by Graco and bearing its name to be free from

3309828EQUIPMENT MISUSE HAZARD: Misuse of pressure washer or accessories can cause the equipment to rupture or malfunction andresult in serious in

4 309828Component IdentificationGun and WandHigh PressureHose ConnectionOn/Off Engine Switch (side)Water Pump Oil FillEngine Oil FillTip StorageHose R

5309828Shipping DamageCheck pressure washer for shipping damage. Notify carrier immediately if there is any damage.Initial SetupOilEngine is shipped

6 309828InstallationConnect High–Pressure Hose and GunConnect high–pressure hose between the pump outlet and gun inlet.Both of these connections are m

7309828PRESSURE RELIEFFollow these instructions whenever you are instructed to relieve pressure, stop spraying formore than 10 minutes, check or servi

8 3098281. Check oil level of engine.Startup Always use this startup procedure to ensure that the pressure washer is startedsafely and properly. A

93098284. Trigger gun until a constant stream of water sprays from tip indicating air is purged from the system.5. Be sure spark plug ignition ca