Graco 332101A Bedienungsanleitung

Instructions Dispensit 1095 Air/Oil Drive Dispense Valve 332101A EN Important Safety Instructions Read all warn

OPERATING PROCEDURES DRY RUN 1. Attach the pneumatic supply lines from the air line fittings on the valve to the air supply outlets on the air contro

OPERATING PROCEDURES OUTPUT VERIFICATION 1. Position a clean container under the valve outlet. 2. Set the stroke of the metering rod to desired shot

OPERATION ADJUSTMENTS Adjust the 1095 Valve for proper operation as follows (refer to the 1095 General Illustration on page 7): 1. Make sure that

PERIODIC MAINTENANCE DISASSEMBLY – METERING UNIT Refer to the 1095 General Illustration on page 7 to remove the metering unit from the 1095. 1. N

MODEL 1095 METERING UNIT ILLUSTRATION

PERIODIC MAINTENANCE ASSEMBLY – METERING UNIT Refer to the Metering Unit Illustration on page 12 and the drawings in the back of this manual for y

PERIODIC MAINTENANCE ASSEMBLY – METERING UNIT Install the Seal Plate Cups on the Main Body 3. Install a lubricated O-ring (20) on the left side

TROUBLESHOOTING Review the symptoms below for operating difficulties. With each problem there are one or more possible causes to investigate. NOTH

MODEL 1095 RECOMMENDED SPARE PARTS Note: These parts are routine supply items or wear parts not covered by warranty for normal wear. Quantity De

GENERAL GUIDELINES FOR O-RINGS AND U-CUP SEALS Sizes and materials of construction for O-rings and U-cup seals are selected by Liquid Control based

Quick Start Up Initial Start up  Install the Air Oil unit in the normal upright position.  It is not required to install material to the dispen

Graco warrants all equipment referenced in this document which is manufactured by Graco and bearing its name to be free from defects in material and w

Quick Start Up con’t Cycle to purge air from system  Activate pneumatic solenoid on top of Air Oil unit either by using override control or using

DISPENSIT® MODEL 1095 DISPENSE VALVE OPERATING AND MAINTENANCE MANUAL General Information ...

GENERAL INFORMATION The Model 1095 Series Metering Rod Positive Displacement Dispense Valve is designed for applications that require precise met

GENERAL ACCESSORIES Liquid Control offers a full line of standard and custom accessories for your dispensing needs including:  Valve Controllers

OPERATION ILLUSTRATION Page 5

SETUP PROCEDURE PRIMING THE AIR/OIL DRIVE OIL The reservoir on the Air/Oil cylinder is not shipped wetted. When filling, be sure the unit is m

MODEL 1095 GENERAL ILLUSTRATION Pag